Hydrostatic Testing also known as ‘hydro testing’ is a process where components such as piping systems, gas cylinders, boilers, and pressure vessels are tested for strength and leaks. Hydro tests are often required after shutdowns and repairs in order to validate that equipment will operate under desired conditions once resumed to service.
Furthermore, hydrostatic testing cannot be performed during normal operations and cannot monitor equipment for leaks after the test has been performed. On-stream equipment integrity is best managed by an effective fixed equipment mechanical integrity program.
Although hydrostatic testing is considered to be a nondestructive testing method, equipment can rupture and fail if the inspection exceeds a specified test pressure or if a small crack propagates rapidly.
Common Methods in Hydrostatic Testing
There are three common methods in hydrostatic testing techniques that are used to test small pressure vessels and cylinders: the water jacket method, the direct expansion method, and the proof testing method.
Water Jacket Method
In order to conduct this method in hydrostatic testing techniques, the vessel is filled with water and loaded it into a sealed chamber (called the test jacket) which is also filled with water. The vessel is then pressurized inside the test jacket for a specified amount of time. This causes the vessel to expand within the test jacket, which results in water being forced out into a glass tube that measures the total expansion. Once the total expansion is recorded, the vessel is depressurized and shrinks to its approximate original size. As the vessel deflates, water flows back into the test jacket.
Sometimes, the vessel does not return to its original size. This second size value is called permanent expansion. The difference between the total expansion and permanent expansion determines whether or not the vessel is fit-for service. Typically the higher the percent expansion, the more likely the vessel will be decommissioned.
Direct Expansion Method
The direct expansion method in hydrostatic testing techniques involves filling a vessel or cylinder with a specified amount of water, pressurizing the system, and measuring the amount of water that is expelled once the pressure is released. The permanent expansion and the total expansion values are determined by recording the amount of water forced into the vessel, the test pressure, and amount of water expelled from the vessel.
Proof Pressure Method
The proof pressure test applies an internal pressure and determine if the vessel contains any leaks or other weakness such as wall thinning that may result in failure. In the United States, this method for hydrostatic technique is only permitted when the U.S. Code of Federal Regulations does not require permanent and total expansion values to be recorded.
For pipelines, hydrostatic testing is conducted while the pipeline is out of service. All oil or natural gas is typically vented off, and the line is mechanically cleaned prior to hydrostatic testing. In any case, operators and inspectors should consider the properties of the hydrostatic testing fluid medium and how the medium may have an effect on the hydrostatic testing equipment. For example, water is a good environment for corrosion to take place. Therefore, the hydrostatic testing equipment should be properly dried and contaminate free before starting operations.
Request Report Sample@ https://www.futuremarketinsights.com/reports/sample/rep-gb-6539